UniFi Swiss Army Knife Table Stand

Purpose-built table stand for the UniFi Swiss Army Knife Ultra (UK-Ultra). Lifts the access point off the desk and holds it upright on any flat surface — no wall, ceiling or pole required.

The Ubiquiti UACC-UK-Ultra-TS is the official desktop stand for the UniFi Swiss Army Knife Ultra access point. The UK-Ultra ships with wall, ceiling and pole hardware in the box, but table mounting is the one option Ubiquiti sells separately — and this is the accessory that unlocks it.

At 92.7 × 41.8 × 58.8 mm and just 98 g, the stand takes up roughly the footprint of a coaster. It keeps the AP standing free and clear rather than lying flat on a desk, which matters more than it sounds: a horizontal AP sitting on a benchtop radiates into the desk surface and whatever is stacked around it. Standing it upright puts the antennas where they can actually work.

Why put a UK-Ultra on a stand?

Better real-world coverage. The UK-Ultra's internal antennas are designed for an upright or mounted orientation. Laying the unit flat on a shelf is the worst case for signal — a stand restores the intended radiation pattern and gets the chassis away from metal shelving, monitor arms and cable spaghetti.

Deployments where drilling isn't an option. Leased offices, heritage buildings, retail fit-outs, pop-up sites, trade-show stands, exam halls and short-term event WiFi all need a tidy AP that can be set down and picked up again. The table stand turns a fixed-install AP into a portable one.

Fast diagnostics and staging. Bench-testing a UK-Ultra before a site visit, running a temporary uplink, or leaving an AP on a service desk for a week is far tidier with a stand than with the unit propped against a monitor.

A finished look. Matching UniFi white, low profile, and no visible hardware — it reads as part of the product rather than a bolt-on.

Built to the same standard as the AP

The stand is moulded from the same engineering plastics Ubiquiti uses across the UniFi Swiss Army Knife accessory range: a thermoplastic polyester elastomer, polycarbonate, polybutylene terephthalate and polyoxymethylene blend. That combination is chosen for rigidity where the AP clips in and grip where the stand meets the desk, and it won't yellow or go brittle the way cheap ABS third-party stands do.

Compatibility

Designed exclusively for the UniFi Swiss Army Knife Ultra (UK-Ultra) access point. It is not compatible with U6, U7 or E7 series access points, which use their own mounting systems.

The UK-Ultra itself is a WiFi 5 (802.11ac) dual-band AP with 2×2 MIMO on both bands, roughly 115 m² (1,250 ft²) of coverage from its internal antennas, support for 200+ connected clients, a Gigabit Ethernet uplink, PoE power and an IPX6 weatherproof rating — so the same unit can move from an outdoor pole to a reception desk and back.

What you'll still need

The stand is a mounting accessory only. The UK-Ultra is PoE-powered and Ubiquiti doesn't include an injector, so a UniFi PoE switch or an 802.3af injector is required separately, along with an Ethernet run to the desk.