UISP Fiber Outdoor Terminal Box

Weatherproof, pole-mountable enclosure that protects outdoor UISP Fiber devices from rain, sun and dust. IPX5-rated UV-stabilised polycarbonate housing with a full pole-mounting and screw kit included.

Key features

• IPX5-rated weatherproof housing — protection against low-pressure water jets from any direction.
• UV-stabilised polycarbonate construction — resists sun degradation in long-term outdoor service.
• Ø35–60 mm pole mounting — fits standard risers, masts and drop poles.
• Complete mounting kit included — cable strap, metal strap, pole mount and screws in the box.
• Compact 249 × 218 × 60 mm footprint — low visual impact on residential and commercial facades.
• Lightweight 680 g — no structural load concerns on light poles or brackets.
• Purpose-designed for outdoor UISP Fiber devices — proper cable routing and strain relief, not a generic enclosure.

Keep outdoor fibre gear working, season after season

Outdoor fibre terminations fail for boring reasons: driving rain, UV embrittlement, a loose service loop chafing through in the wind. The Ubiquiti UACC-UF-Terminal-Box is Ubiquiti's answer to all three — a purpose-built outdoor enclosure that houses your UISP Fiber device and its fibre termination in one sealed, pole-mounted box.

It's the accessory that turns a bench-grade install into a service-grade one, and at the low end of the accessory price bracket, it's cheap insurance against a truck roll.

IPX5-rated, UV-stabilised protection

The housing is moulded from UV-stabilised polycarbonate, so it resists the yellowing and brittleness that kills untreated plastics after a few summers in direct sun. Ubiquiti rates the enclosure IPX5 — protection against low-pressure water jets from any direction, which covers wind-driven rain and general weather exposure.

Mounts to the pole you already have

The included pole-mounting kit, metal strap, cable strap and screw kit clamp the box to poles from Ø35 mm to Ø60 mm (Ø1.38" to 2.36") — the range that covers most standard service risers, mast sections and drop poles. No fabrication, no separate bracket purchase, no trip back to the van.

At 249 × 218 × 60 mm including the mount and just 680 g, it stays discreet on a residential facade or riser while leaving room inside to dress a service loop properly.

Purpose-built for the UISP Fiber family

This is a Ubiquiti enclosure designed around Ubiquiti hardware, so the internal layout, cable routing and strain-relief points suit outdoor UISP Fiber ONUs rather than forcing you to improvise inside a generic junction box.

Resellers and field installers commonly pair it with the UFiber Nano, UFiber Loco and UF-AE — verify fit against your specific device and firmware generation before ordering in volume, as Ubiquiti's own spec sheet lists the enclosure generically rather than publishing a device compatibility matrix.

Built for the crews doing the installs

• WISPs and FTTH operators standardising outdoor CPE enclosures across a rollout.
• Fibre contractors who need a repeatable, tidy termination point on drop poles.
• MDU and campus deployments where the ONU sits outside the building envelope.
• Rural and remote sites where a failed enclosure means a long drive back.